InGen MillTek YinJiang

Middle East · Complete tube mill line · 2017

Middle East · Two ERW tube mill lines: YJ-165 and YJ-76

In 2017 we delivered two ERW tube mill lines, a YJ-165 and a YJ-76, with forming rolls for both lines, to a steel tube producer in the Middle East. The YJ-165 line makes galvanized round, square and rectangular tubes of Φ76–167 mm with 2–6 mm wall; the YJ-76 line covers Φ25–89 mm with 0.5–3 mm wall. Ordered in May 2017 and shipped in two batches in August–September 2017; power supply 415 V / 50 Hz.

Entry-section pinch-roll leveler of an ERW tube mill line in our workshopIn our workshop before shipment
Entry-section pinch-roll leveler

Scope of supply

  • One YJ-165 ERW tube mill line, entry section: single-head hydraulic uncoiler, coil car, 7-roll leveler, powered pressing head, integrated shear and butt welder, spiral accumulator
  • Same line, mill section: forming and sizing mill, flying saw and electrical controls
  • One YJ-76 ERW tube mill line, entry section: double-head manual uncoiler, 350 hydraulic shear, two-shaft feeder, support racks, spiral accumulator
  • Same line, mill section: forming and sizing mill, flying saw and electrical controls
  • Forming rolls (tooling) for both lines
  • A shear and butt welder and a zinc-spray unit shipped separately in early 2017

Related equipmentYJ-76 Tube MillYJ-165 Tube Mill

Ask about a similar project

More project cases

All project cases

Tell us your material, tube profile and output

We discuss the suitable model and configuration for your product and plant. Every line is configured per project, and pricing follows the configuration.

Discuss your requirements