Export Tube Mill Voltage and Frequency: 380–480 V, 50/60 Hz
Tube mill lines are configured for the buyer's grid. See export supplies, control transformers, why 50 and 60 Hz are not interchangeable, and inquiry details.
Read articleTechnical guides · Company news
News & Guides
Company news and practical guides to tube mill equipment and production planning.
Technical guides
Tube Mill Delivery, Foundation Drawings and Commissioning
From tube mill contract to first tube: delivery time, layout and foundation drawings, site preparation, packing, installation, commissioning and training.
Read articleSingle- or Double-Head Uncoiler: Coil Weight and Strip Width
Start with the full coil weight. Double-head uncoilers suit narrower strip and lighter coils; single-head units with a coil car suit wide strip and heavy coils.
Read articleComparing tube mill proposals: scope and factory interfaces
Two complete tube mill proposals may cover different equipment, controls, tooling and site work. Compare them with an equipment list and interface schedule.
Read articleMotor power, HF power and incoming electrical capacity
Motor power, HF power rating and plant electrical capacity are different quantities. Confirm the point, unit and conditions of each before sizing the supply.
Read articleFlying saw selection: line speed, cut length and full cycle
A flying saw must match the tube, line speed, cut length and full operating cycle. High tracking speed alone does not prove continuous cutting at every length.
Read articleTube mill cooling: flow rate is not heat-rejection capacity
Cooling is specified by flow, pressure, supply and return temperatures, and heat load. Tank volume or pump power alone does not show how much heat is removed.
Read articleSelecting a tube mill: start with your production mix
A diameter range is only a starting point. List material, sizes, wall thickness, product mix, cut length and quality needs before comparing configurations.
Read articleTube mill acceptance: define conditions that can be checked
Acceptance needs defined products, configuration, operating conditions, inspection methods and records. Closing one issue does not mean the line is accepted.
Read article