Middle East · Entry equipment, Spiral accumulator · 2024

Middle East · Entry equipment and run-out table for a large tube mill

In 2024 we built the entry equipment and a 30 m run-out table for a large tube mill at a tube producer in the Middle East. The tube mill itself came from another manufacturer; our supply covered only the entry section and the run-out table. Site photographs show the run-out table installed at the customer's plant.

Chain-transfer run-out table at a tube mill, with finished tubes beside it — Run-out table

Through a partner company The tube mill itself was not ours; the list below is our supply.

Scope of supply

16 t single-side hydraulic uncoiler with support arm, and hydraulic coil car
7-roll leveler, peeler with powered hold-down, two-roll pinch unit
Shear and butt welder
8 m floor-type spiral accumulator, two-roll strip feeder and strip supports
30 m run-out table
Hydraulic unit and controls

Ask about a similar project

All project cases

Tell us your material, tube profile and output

We discuss the suitable model and configuration for your product and plant. Every line is configured per project, and pricing follows the configuration.

Discuss your requirements

Scope of supply

More project cases

Tell us your material, tube profile and output